User's Manual

hwc_appendixd.fm
SpectraLink Wireless Telephones
Configuring HiPath Wireless Controller for SpectraLink Telephones
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 421
4. From the VNS Mode drop-down menu, select appropriate mode after
considering the following details:
Note: It is recommended that you should choose Bridge Traffic Locally at
HWC VNS for SpectraLink network deployment.
5. From the DHCP Option drop-down menu, you can select either the Local
DHCP Server or Use DHCP Relay, depending upon your network topology.
6. In the Gateway box, type the network gateway address.
7. In the Mask box, type the appropriate values.
8. In the Address Range boxes (from and to), type the IP address range.
9. From the Assignment Type drop-down menu, select SSID.
10. Under Timeout section, type 2 in the pre and post boxes.
11. Under Next Hop Routing section, type 50000 in the OSPF Route Cost box.
12. Click Save.
D.2.2 Configuring filters
To configure the filters: