User's Manual

hwc_appendixc.fm
optiPoint WL2 Configuration
HiPath Wireless Controller configuration
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 415
• The Priority Override option should normally be cleared. If the phone
and PBX are configured properly, the default DSCP classification should
work well. If you are unsure, sniff the packets over the air and check that
the voice packets are sent with priority 6 or 7 in both UL and DL directions.
To configure Wireless AP radio properties:
1. From the main menu, click Wireless AP Configuration. The HiPath
Wireless AP page is displayed.
2. Click the applicable radio tab.
3. Configure the following radio settings:
• In the DTIM Period box, type 5.
Note: A DTIM Period value of 1 may produce better results if significant
RF interference exists in your environment. Use a DTIM Period value of
5 unless you notice a significant improvement when using a value of 1.
• In the Beacon Period box, type 100 (ms).
• In the RTS/CTS Threshold box, ensure that the default value 2346 is
used.
• In the Frag. Threshold box, ensure that the default value 2346 is used.