User's Manual

optiPoint WL2 Configuration
hwc_appendixc.fm
optiPoint WL2 wireless telephone configuration
A31003-W1050-U100-2-7619
, March 2008
412 HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide
A larger value, for example -65 dBm will cause the phone to scan for
alternate Wireless APs more often, which will result in more wireless
traffic and slightly decreased battery life. A smaller value, for example -75
dBm will cause the phone to roam too late, causing voice interruptions
during roaming.
• In the Preamble Type section, select Short. The short preamble provides
for higher voice capacity.
If legacy pre-11b devices are present in the coverage area or you are
unsure if legacy pre-11b devices are present in the coverage area, select
Long.
To configure WLAN security settings:
1. In the left pane, click Network. The Network: Profile Selection page is
displayed.
2. In the left pane, click WLAN Security. The Network: WLAN Security for
profile page is displayed.
3. Configure the following WLAN security settings:
• Click WEP.