User's Manual

hwc_appendixc.fm
optiPoint WL2 Configuration
optiPoint WL2 wireless telephone configuration
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 411
To configure WLAN settings:
1. In the left pane, click Network. The Network: Profile Selection page is
displayed.
2. In the List of Profiles, click Edit for the profile you want to configure. The
Network: Profile Name page is displayed.
3. In the left pane, click WLAN. The Network: WLAN for profile page is
displayed.
4. Configure the following WLAN settings:
• In the Output Power (in%) drop-down list, click 100.
Use the maximum 100% unless there is a reason to reduce it.
• In the Transmission Rate drop-down, click Auto.
Note: When the Transmission Rate is set to a value, it does not force the
phone to only use that particular PHY transmission rate. Instead, it forces the
phone to only use PHY rates that are smaller or equal to the set rate.
• In the Fragmentation Threshold box, ensure that the default value 2346
is used.
• In the RTS/CTS Threshold box, ensure that the default value 2347 is
used.
• In the Roaming Threshold box, type a roaming threshold between the
range of -75 dBm to -65 dBm, depending on the parameters of the
deployment.