User's Manual

hwc_appendixb.fm
Regulatory information
Wireless APs 26XX and 36XX
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 393
Note: The qualification testing and results are based on above described
antennas, cable types, lengths, and connector types. Other cable lengths and
connector types are also available which are specified by the suffix part of the part
numbers (ex. SR2405135Dxxxxxx, where the xxxxxx suffix represents cable
length and/or connector type). The antenna feedline used in testing are the
minimum cable length. Longer cable may be used with losses greater than or
equal to the cables used for testing. The maximum power settings must be
adjusted according to these tables.
Note: If one of the following antenna is used, you must select an operating
channel (on the Wireless APs configuration pages) and the corresponding
allowed max power from the values listed in Table 39. DO NOT select a higher
power than the value listed in Table 39.
Antenna
Antenna
#1 Cushcraft
SR2405135D
xxxxxx
Antenna
#2 Cushcraft
S24493DSxx
xxxx
Antenna
#3 Cushcraft
SL24513Pxx
xxxx
Antenna
#4
Cushcraft
S24497Pxx
xxxx
Antenna
#5 Hyperlink
Tech
HG2458CUxxx
Antenna
#6
Maxrad
MDO24005P
Txxxxxx
Frequency
(MHz)
Ch. No. Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
Power limit
(dBm)
11b241211618171617 17
241721717171617 17
242231818181818 18
242741818181818 18
243251818181818 18
243761818181818 18
244271818181818 18
244781818181818 18
245291818181818 18
2457 10 18 18 18 18 18 18
2462 11 18 18 18 18 18 18
Table 39 IC Antenna channel-power information