User's Manual

hwc_appendixa.fm
HiPath Wireless Controller’s physical description
LED states and Seven Segment Display (SSD) codes
A31003-W1050-U100-2-7619,
March 2008
HiPath Wireless Controller, Access Points and Convergence Software V5 R1 , C20/C2400 User Guide 373
A.2 LED states and Seven Segment Display (SSD) codes
Firmware initialization:
Note: Although the Active LED will be lit Green during the firmware initialization,
this LED state is irrelevant to the SSD display or the condition. You must ignore
the LED state during the firmware initialization.
Application initialization:
Active
LED
Warning
LED
Error
LED
SSD Codes Condition
Green 0 The processor has started; and the
firmware has taken control.
Green 3 The Host Controller Card has failed to
download Bootloader from Flash.
Green 4 The system is checking firmware
consistency.
Green 5 The system is formatting memory.
Green 6 The system is initializing load device.
Note: If the SSD code is stuck at 6 for
more than a minute, it implies that the
Network Processor Card is installed in
wrong slot.
Green 9 The system is loading subsystem.
Green b The system is starting the operation
system. The system is active.
Table 31 LED states and SSD codes during firmware initialization
Active
LED
Warning
LED
Error
LED
SSD Code Condition
Green 0 Application initialization started.
Green 1 Forwarding Engine initialization
complete. Application initialization.
Green A Application initialization complete.
System active.
Green H System halted. Administrator requested
halting of system.
Table 32 LED states and SSD codes during application initialization