User's Manual

7ML19985LT01 SITRANS LR560 (PROFIBUS PA) – OPERATING INSTRUCTIONS Page 83
mmmmm
Parameters
To clear a fault via SIMATIC PDM:
• Open the menu Device – Acknowledge Faults.
• Select the fault to be cleared from the pull-down menu in Extended
Diagnostics.
• Click on Transfer to clear the fault.
3.3. Trend
Displays the trend of the Process Variables: sensor value, and outputs from AIFB1/
AIFB2. Samples are saved every minute up to 3200 samples.
To view via SIMATIC PDM:
Open the menu View – Process Variables and click on the tab Trend View.
3.4. Electronics Temperature
3.4.1. Minimum Value
The minimum recorded internal electronics temperature of the SITRANS LR560.
3.4.2. Maximum Value
The maximum recorded internal electronics temperature of the SITRANS
LR560.
3.4.3. Internal Temperature
The current internal electronics temperature of the device.
3.5. Condensed Status
When Enable (3.5.1.) is enabled, you can select the level of severity of errors, and
tailor a device response appropriate for your particular process.
•In Event Index (3.6.1.) you can select a particular event or error by means of its
index number.
•In Event Status (3.6.2.) you can assign a status to the selected event.
•In Event Diagnosis (3.6.3.) you can assign a diagnosis to the selected event.
3.5.1. Enable
Select Yes or No to enable/disable Condensed Mode.
3.5.2. Features supported
Read only. Features supported are:
• Condensed Diagnostics
• Extended Diagnostics
• Application Relationships
3.5.3. Features enabled
Read only. Lists those features that have been enabled.
Note: When cyclic communication is in progress, Condensed Status Mode
cannot be changed.
Options
NO (disabled)
* YES (enabled)