User's Manual

7ML19985KB01 SITRANS LR560 (mA/HART) – INSTRUCTION MANUAL Page 79
mmmmm
Parameters
1.6. Copy Firmware from Display
Transfers firmware from the local display interface to a device.
SW DOWNLOAD is displayed, then the device returns to Measurement mode.
2. Setup
2.1. Device
2.1.1. Long Tag
Text that can be used in any way. A recommended use is as a unique label for
a field device in a plant. Limited to 32 ASCII characters. Read only on device,
Read/Write using SIMATIC PDM and AMS..
2.1.2. Tag
Text that can be used in any way. A recommended use is as a unique label for
a field device in a plant. Limited to 8 ASCII characters. Read only on device,
Read/Write using SIMATIC PDM and AMS.
2.1.3. Descriptor
Text that can be used in any way. Limited to 16 ASCII characters. No specific
reommended use. Read only on device, Read/Write using SIMATIC PDM and
AMS.
2.1.4. Message
Text that can be used in any way. Limited to 32 ASCII characters. No specific
recommended use. Read only on device, Read/Write using SIMATIC PDM and
AMS.
2.1.5. Installation Date
Date the device was first commissioned. Read only locally. Can be written via
HART (dd mm yyyy).
2.1.6. Hardware Revision
Read only. Corresponds to the electronics hardware of the SITRANS LR560.
Notes
• Do not interrupt power supply during transfer.
Notes:
• Default settings in the parameter tables are indicated with an asterisk (*) unless
explicitly stated.
• Values shown in the following tables can be entered via the handheld programmer.
• Press RIGHT arrow to Edit.
• Press DOWN arrow to select
Start and RIGHT arrow to begin
the transfer.