User's Manual

Page 66 SITRANS LR560 (mA/HART) – INSTRUCTION MANUAL 7ML19985KB01
mmmmm
AMS Device Manager
Service Schedule [see Service Schedule (4.7.) on page 104]
•Service Interval
• Time since last Service
• Time until next Service
• Activation of Reminders
• Reminder 1 before Service (Required)
• Reminder 2 before Service (Demanded)
• Click on Service Performed to reset Time Until Next Service to the full service
interval.
Calibration Schedule [see Calibration Schedule (4.8.) on page 107]
• Calibration Interval
• Time since last Calibration
• Time Until Next Calibration
• Activation of Reminders
• Reminder 1 before Calibration (Required)
• Reminder 2 before Calibration (Demanded)
• Click on Calibration Performed to reset Time Until Next Calibration to the full
calibration interval.
Electronic Temperature
• Electronic Temperature
• Lowest Value
• Highest Value
Wear (see Powered Hours (4.3.) on page 103)
• Time in Operation (Reset to 0 after clicking Sensor Replaced)
• Poweron Resets
Communication
Navigate to Communication to read the following:
Long Tag; Manufacturer’s ID; Device ID; Product ID; Device Revision; EDD Revision; Universal
Command
Security
Navigate to Configure/Setup > Security to access:
Remote Access [see Remote Lockout (5.2.) on page 110]
• Write Protection
Local Access
• Local Operation Enable
See also
Password Protection on page 68.
Note: If access control is changed via the handheld programmer to limit remote
access, it can only be reset via the handheld programmer. See Remote Lockout
(5.2.)
on page 110.