User's Manual

Page 60 SITRANS LR560 (mA/HART) – INSTRUCTION MANUAL 7ML19985KB01
mmmmm
AMS Device Manager
Changing parameter settings using AMS Device Manager
1) Adjust parameter values in the parameter value field in Configure/Setup view, then
click on Apply to write the new values to the device. The parameter field will display
in yellow until the value has been written to the device.
2) Click on OK only if you wish to update all parameters and exit AMS.
Operation
Navigate to Configure/Setup > Operation and click on Operation to open the dialog window for
access to:
General:
• Select Analog Output (see Select Analog Output on page 49)
• Master Reset (see
Master Reset on page 50)
Simulation/Test
• Self Test (see Self Test on page 49)
• Loop Test (see
Loop Test on page 49)
Notes:
• For a complete list of parameters, see Parameter Reference on page 76.
• For more detailed explanations of the parameters listed below see the pages
referenced.