User's Manual
Table Of Contents
- Table of Contents
- SITRANS LR 460
- Specifications
- Installation
- Wiring
- 4-20 mA Start Up
- Local Operation
- LCD menu structure
- HART Communications
- Remote operation via PROFIBUS PA
- PROFIBUS PA Profile Structure
- Appendix A: Parameter Descriptions
- 1. Identification
- 2. Input
- 3. Output
- 5. Maintenance settings
- 6. Condensed Status Setup
- 6.1. Condensed Status Mode
- 6.1.1. Loss of Echo S0 (Status; Diagnosis)
- 6.1.2. Cable Fault S1 (Status; Diagnosis)
- 6.1.3. No Tech Power S2 (Status; Diagnosis)
- 6.1.4. Device Lifetime Maintenance Required Limit S3 (Status; Diagnosis)
- 6.1.5. Device Lifetime Maintenance Demanded Limit S4 (Status; Diagnosis)
- 6.1.8. Sensor Lifetime Maintenance Demanded Limit S7 (Status; Diagnosis)
- 6.1.9. Device Service Maintenance Required Limit S8 (Status; Diagnosis)
- 6.1.10. Device Service Maintenance Demanded Limit S9 (Status; Diagnosis)
- 6.1.11. LTB Scale S10 (Status; Diagnosis)
- 6.1.12. Internal Temp Sensor S11 (Status; Diagnosis)
- 6.1.13. Internal Temp High S12 (Status; Diagnosis)
- 6.1.16. AIFB2 PV Range S15 (Status; Diagnosis)
- 6.1.19. Calibration Schedule Maintenance Demanded Limit S18 (Status; Diagnosis)
- 6.1.30. Memory EEPROM S29 (Status; Diagnosis)
- 6.1.31. Memory EEPROM Flags S30 (Status; Diagnosis)
- 6.1.32. Memory Flash S31 (Status; Diagnosis)
- 6.1.33. Ident Violation S32 (Status; Diagnosis)
- 6.1.34. Internal Temperature Calibration S33 (Status; Diagnosis)
- 6.1. Condensed Status Mode
- Appendix B: Technical Reference
- Appendix C: Troubleshooting
- Appendix D: Maintenance
- Appendix E: Software Revision History
- Glossary
- Index
7ML19985JM01 SITRANS LR 460 – INSTRUCTION MANUAL Page 33
mmmmm
C: Local Operation
Local Operation
Programming via the handheld programmer
Although the complete range of parameters is only accessible via PDM
1
, you can access
and adjust many of the parameters via the Siemens Milltronics infrared handheld
programmer.
• For the complete list of parameters, see
Appendix A: Parameter Descriptions
on
page 58.
•
LCD menu structure
on page 37 gives a list of all parameters accessible via the
handheld programmer, preceded by the menu number.
Parameter Menu Structure
The parameters are organized into function groups, and arranged in a 4-level menu
structure. For example:
1. Identification
1.2. Configuration
1.2.2. Remote Lock.
The LCD Display
Details on the LCD display are given in
Start Up
, page 24 onwards.
r
1.
Please see page 46 for
Remote operation via PROFIBUS PA
Note: The ARROW buttons shown below are required for programming
this product. The additional buttons on the hand programmer do not
apply to SITRANS LR 400.
Key Programming Mode
Parameter scroll UP
Parameter scroll DOWN
LEFT Arrow (or CANCEL)
RIGHT Arrow (or ENTER)
C
SITRANS LR 400
buttons