User's Manual
Table Of Contents
7ML19985FH04 SITRANS LR 400 – INSTRUCTION MANUAL Page 36
mmmmm
Parameters (HART)
2.3: Volume (F = m
3
)
Volume of measured medium (set unit using Parameter 4.1.2 [Volume Unit])
2.4: Mass (for qualified personnel only)
This parameter is for Factory Authorized Personnel Only.
2.5: Current Output
Value of the analog output in mA
When the device electronics are working properly, the displayed current value will
correspond to the measured output current.
2.6: Digital Output
State of digital output
3. Diagnostics
3.1: Status
Here you can access current status messages of the device. Parameter 3.1.1 is always
accessible; other parameters (Parameter 3.1.x) appear in the appropriate order if they
contain error messages.
3.1.1: Wear
3.1.1.1: Operating Hours
Total previous operating time of the device in hours (approximate value)
3.1.1.2: Maximum Temperature (F = 26 °C)
Previous maximum internal temperature of the device
3.1.1.3: Minimum Temperature (F = 26 °C)
Previous minimum internal temperature of the device
3.1.1.4: Aging
Approximate value for the previous life of the device in % (100% = approx. 10 years)
Note: This temperature must not exceed 85 °C (185 °F) or warranty may be void.