User's Manual
Table Of Contents
- Table of Contents
- SITRANS LR260 Overview
- Specifications
- Installation
- Wiring
- Quick Start via local operation
- Operating via SIMATIC PDM
- Parameter Reference
- Pull-down menus via SIMATIC PDM
- Quick Start Wizard
- 1. Quick Start
- 2. Setup
- 3. Diagnostics
- 3.1. Echo Profile
- 3.14. Measured Values (MEAS. VALUES)
- 3.15. Remaining Device Lifetime (REMAIN. DEV. LIFE.)
- 3.15.2. Remaining Device Lifetime (REMAIN. LIFETIME)
- 3.15.3. Maintenance Required Limit (MAINT. REQ. LIMIT)
- 3.15.4. Maintenance Demanded Limit (MAINT. DEM. LIMIT)
- 3.15.5. Maintenance Alert Activation (ALERT ACTIVATION)
- 3.15.6. Total Expected Device Life (TOTAL EXP. LIFE)
- 3.15.7. Maintenance Status (MAINT. STAT.)
- 3.15.8. Acknowledge Status (ACK STATUS)
- 3.15.9. Acknowledge (ACK)
- 3.16. Remaining Sensor Lifetime (REMAIN SENS. LIFE.)
- 3.16.2. Remaining Sensor Lifetime (REMAIN. LIFETIME)
- 3.16.3. Maintenance Required Limit (MAINT. REQ. LIMIT)
- 3.16.4. Maintenance Demanded Limit (MAINT. DEM. LIMIT)
- 3.16.5. Maintenance Alert Activation (ALERT ACTIVATION)
- 3.16.6. Total Expected Sensor Life (TOTAL. EXP. LIFE)
- 3.16.7. Maintenance Status (MAINT. STATUS)
- 3.16.8. Acknowledge Status (ACK. STATUS)
- 3.16.9. Acknowledge (ACK.)
- 4. Service
- 4.1. Device Reset
- 4.2. Manufacture Date (MANUF. DATE)
- 4.3. LCD Fast Mode
- 4.4. LCD Contrast
- 4.11. Memory Test (MEM. TEST)
- 4.16.1. Time Last Serviced (TIME LAST SERV.)
- 4.16.2. Remaining Lifetime (REMAIN LIFETIME)
- 4.16.3. Maintenance Required Limit (MAINT. REQ. LIMIT)
- 4.16.4. Maintenance Demanded Limit
- 4.16.5. Maintenance Alert Activation
- 4.16.6. Total Service Interval
- 4.16.7. Maintenance Status (MAINT. STAT)
- 4.16.8. Acknowledge Status (ACK. STATUS)
- 4.16.9. Acknowledge (ACK.)
- 4.17. Calibration Interval (CALIB. INTERVAL)
- 4.17.1. Time Last Calibrated (TIME LAST CAL.)
- 4.17.2. Remaining Lifetime (REMAIN LIFETIME)
- 4.17.3. Maintenance Required Limit (MAINT. REQ. LIMIT)
- 4.17.4. Maintenance Demanded Limit (MAINT. DEM. LIMIT)
- 4.17.5. Maintenance Alert Activation
- 4.17.6. Total Calibration Interval (TOTAL CALIB. INTRV.)
- 4.17.7. Maintenance Status (MAINT. STAT.)
- 4.17.8. Acknowledge Status (ACK. STATUS)
- 4.17.9. Acknowledge (ACK.)
- 5. Communication
- 6. Security
- 7. Language
- Appendix A: Alphabetical Parameter List
- Appendix B: Troubleshooting
- Appendix C: Maintenance
- Appendix D: Technical Reference
- Appendix E: Application Example
- Appendix F: HART Communications
- Appendix G: Firmware Revision History
- Glossary
- Index
- LCD menu structure
iii
mmmmm
Table of Contents
Appendix C: Maintenance .............................................................................................95
Unit Repair and Excluded Liability ..................................................................................................95
Appendix D: Technical Reference ...............................................................................96
Principles of Operation ......................................................................................................................96
Echo Processing .................................................................................................................................96
Process Intelligence .................................................................................................................96
Time Varying Threshold (TVT) Curves .................................................................................97
Echo Lock ....................................................................................................................................97
Echo Position Detection ..........................................................................................................97
Auto False Echo Suppression ................................................................................................98
Measurement Range .........................................................................................................................98
Near Range ................................................................................................................................98
Far Range ....................................................................................................................................99
Measurement Response ...................................................................................................................99
mA Output .............................................................................................................................................99
Damping ..............................................................................................................................................100
Loss of Echo (LOE) ............................................................................................................................100
Fail-safe Mode ...................................................................................................................................100
Fail-safe Timer .........................................................................................................................101
Fail-safe Material Level .........................................................................................................101
Fail-safe Level ..........................................................................................................................101
Process Pressure/Temperature derating curves .....................................................................102
Horn Antenna .....................................................................................................................................103
Loop power .........................................................................................................................................104
Typical Connection Drawing ................................................................................................104
Allowable operating area of SITRANS LR260 ..................................................................104
Startup Behavior .....................................................................................................................105
Appendix E: Application Example ..............................................................................107
Flour in steel storage vessel, level measurement ....................................................................107
Appendix F: HART Communications .........................................................................109
SIMATIC PDM ...................................................................................................................................109
HART Electronic Device Description (EDD) ................................................................................109
HART Version ...........................................................................................................................109
HART Burst Mode ...................................................................................................................109
HART Multidrop .......................................................................................................................109
HART Communicator 375 Menu Structure ................................................................................110
Supported HART Commands .........................................................................................................113
Universal and Common Practice Commands ..................................................................113
Device Specific Commands ..................................................................................................113
Appendix G: Firmware Revision History ...................................................................114
Glossary ..........................................................................................................................115
Index ................................................................................................................................119
LCD menu structure ......................................................................................................121