User's Manual
Table Of Contents
- Table of Contents
- SITRANS LR250 Overview
- Specifications
- Installation
- Wiring
- Operating via the handheld programmer
- Operating via SIMATIC PDM
- Functions in SIMATIC PDM
- Quick Start Wizard via SIMATIC PDM
- Changing parameter settings using SIMATIC PDM
- Parameters accessed via pull-down menus
- Operating via AMS Device Manager
- Functions in AMS Device Manager
- Features of AMS Device Manager
- Device Description (DD)
- Configuring a new device
- Startup
- Pull-down menu access
- Device configuration
- Quick Start Wizard via AMS Device Manager
- Maintenance and Diagnostics
- Remaining Device Lifetime [see Remaining Device Lifetime (4.2.) on page 99]
- Remaining Sensor Lifetime [see Remaining Sensor Lifetime (4.3.) on page 102]
- Service Schedule [see Service Schedule (4.4.) on page 105]
- Calibration Schedule [see Calibration Schedule (4.5.) on page 108]
- Electronic Temperature
- Wear (see Wear on page 56)
- Communication
- Security
- Device Diagnostics
- AMS Menu Structure
- Functions in AMS Device Manager
- Parameter Reference
- 1. Quick Start
- 2. Setup
- 3. Diagnostics
- 4. Service
- 5. Communication
- 6. Security
- 7. Language
- Appendix A: Alphabetical Parameter List
- Appendix B: Troubleshooting
- Appendix C: Maintenance
- Appendix D: Technical Reference
- Principles of Operation
- Echo Processing
- Analog Output
- Maximum Process Temperature Chart
- Process Pressure/Temperature derating curves
- Loop power
- Appendix E: Application Examples
- Appendix F: HART Communications
- Appendix G: ATEX Certificates
- Appendix H: Firmware Revision History
- Glossary
- Index
- LCD menu structure
Page 62 SITRANS LR250 (HART) – INSTRUCTION MANUAL 7ML19985JE03
mmmmm
AMS Device Manger
Master Reset
• Navigate to Configure/Setup > Operation
• In the General field click on Master Reset and accept the option Factory Defaults.
Pull-down menu access
A pull-down menu under Actions gives alternative access to several features.
Scan Device
• Open the menu Actions – Scan Device.
• Scan Device uploads parameters from the device (synchronizes parameters).
Device configuration
1) Navigate to Configure/Setup > Operation and click to open the dialog window.
2) In the General field, click on Master Reset and perform a reset to Factory Defaults.
3) Open the pull-down menu Actions – Scan Device to synchronize parameters (upload
parameters from the device to AMS).
4) Configure the device via the Quick Start wizard.
Action menu items
Master
Reset