User's Manual

7ML19985JE03 SITRANS LR250 (HART) – INSTRUCTION MANUAL Page 111
mmmmm
Parameters
4.5.6. Reminder 2 (Demanded)
If Time until Next Calibration (4.5.3.) is equal to or less than this value, the device
generates a Maintenance Demanded reminder.
a) Modify values as required.
b) Set Reminder Activation (4.5.4.) to the desired option.
4.5.7. Maintenance Status
Indicates which level of maintenance reminder is active.
In SIMATIC PDM, open the menu View – Device Status, click on the
Maintenance tab and check the Calibration Schedule Status window.
4.5.8. Acknowledge Status
Indicates which level of maintenance reminder has been acknowledged.
In SIMATIC PDM, open the menu View – Device Status, click on the
Maintenance tab and check the Calibration Schedule Status window.
4.5.9. Acknowledge
Acknowledges the current maintenance reminder.
To acknowledge a reminder via SIMATIC PDM:
a) Open the menu View – Device Status and click on the Maintenance tab.
b) In the Calibration Schedule Status section click on Acknowledge
Warnings.
To acknowledge a reminder via the handheld programmer:
a) Press RIGHT arrow twice to open parameter view and activate Edit
Mode.
b) Press RIGHT arrow to acknowledge the reminder.
4.6. Manufacture Date
The date of manufacture of the SITRANS LR250 (yy mm dd).
4.7. Powered Hours
Displays the number of hours the unit has been powered up since manufacture.
In SIMATIC PDM, open the menu Device – Wear.
4.8. Power-on Resets
The number of power cycles that have occurred since manufacture.
In SIMATIC PDM, open the menu Device – Wear.
Values
Range: 0 to 20 years
Default: 0.019 years