User's Manual

Remote operation
7.1 Operating via AMS Device Manager
SITRANS LR250 (FOUNDATION FIELDBUS)
Operating Instructions, 01/2014, A5E32221411-AB
89
7.1.9.6
Maintenance & Diagnostics (LTB)
Note
For more detailed explanations of the parameters listed below see the pages referenced.
Navigate to
Configure/Setup > LTB > Maintenance and Diagnostics
for access to:
Remaining Sensor Lifetime
[see
Remaining Sensor LIfetime (4.3.)
]
● Lifetime (expected) [see
Lifetime (expected) (4.3.1.)
]
● Time in Operation [see
Time in Operation (4.3.2.)
]
● Remaining Lifetime [see
Remaining Lifetime (4.3.3.)
]
● Activation of Reminders [see
Activation of Reminders (4.3.4.)
]
● Reminder 1 before Lifetime (Required) [see
Reminder 1 before Lifetime (Required) (4.3.5.)
]
● Reminder 2 before Lifetime (Demanded) [see
Reminder 2 before Lifetime (Demanded)
(4.3.6.)
]
1. Open the window
Remaining Sensor Lifetime
2. After modifying values/units as required, click on
Apply
to accept the change.
● Click on
Sensor Replaced
to reset Time in Operation to 0 hours
● Click on
Snooze for 1 Year
to add a year to the Total Expected Sensor Life