User's Manual

Remote operation
7.2 Operating via AMS Device Manager
SITRANS LR250 (HART)
Operating Instructions, 01/2014, A5E32220602-AB
95
Changing parameter settings using AMS Device Manager
Note
For a complete list of parameters, see
Parameter Reference (Page 113).
For more detailed explanations of the parameters listed below see the pages referenced.
1. Adjust parameter values in the parameter value field in Configure/Setup view, then click on
Apply
to write the new values to the device. The parameter field will display in yellow until the
value has been written to the device.
2. Click on
OK
only if you wish to update all parameters and exit AMS.
Operation
Navigate to
Configure/Setup > Operation
and click on
Operation
to open the dialog window for
access to:
General
● Select Analog Output [see Select Analog Output (Page 81)]
● Master Reset [see Master Reset (Page 82)]
Simulation/Test
● Self Test [see Self Test (Page 81)]
● Loop Test [see Loop Test (Page 82)]