User's Manual
Table Of Contents
- Table of Contents
- General Information
- Specifications
- Installation
- Location
- Dimensions: IQ Radar 300 with Rod Antenna
- Dimensions: Threaded Rod
- Dimensions: Horn
- Mounting
- Rod Assembly
- Mounting: Rod Assembly
- Mounting: Manhole Covers
- Mounting: Horn Antennas
- Mounting: Waveguide Antenna
- Mounting: Stillpipe or Sidepipe
- Mounting: Horn with Waveguide Extensions
- Mounting: Sanitary Mounting
- Mounting: Location
- Interconnection
- Start Up
- Operation(
- Application Examples
- Parameter Descriptions
- _
- _
- Quick Start Parameters (P001 to P007)
- Volume Parameters (P050 to P053)
- Display and Reading Parameters (P060 to P063)
- Fail-Safe Parameters (P070 to P072)
- mA Parameters (P200 to P219)
- Independent mA Setpoints Parameters (P210 and P211)
- Profile Record Parameters (P330 to P337)
- Auto Record ON and OFF Setpoint Parameters (P334 to P337)
- Installation Records Parameter
- Range Calibration Parameters
- Rate Parameters
- Measurement Verification Parameters
- Communication Parameters
- Echo Processing Parameters
- Algorithm Parameters
- TVT Adjustment Parameters
- P837 Auto Near TVT
- Test Parameters
- _
- Communications: Modbus Register Map
- Communications: Data Types
- Error Handling
- Troubleshooting
- Maintenance(
- Appendix I
- Appendix II
- Appendix III
- Appendix IV
- Appendix V
PL-611 IQ Radar 300 Page 75
Parameters
Parameters
Parameters
Parameters
Related Parameters
• P804 Confidence Threshold
P806 Echo Strength
Displays the strength of the selected echo, in dB above 1 µV rms.
Values (view only) Display: 0 to 9
P807 Noise
Displays the average and peak ambient noise (in dB above 1 µV RMS) being processed.
x = average (-9 to 99)
Values (view only)
y = peak (-9 to 99)
The noise level is a combination of transient noise and electrical noise (receiving
circuitry).
Algorithm Parameters
P820 Algorithm
Selects the algorithm to be applied to the echo profile in order to extract the true echo.
[verify chart]
1
ALF = flat A
AA
Area, L
LL
Largest, and F
FF
First average
2
A = flat A
AA
Area only
3
L = flat L
LL
Largest only
4
F= flat F
FF
First only
5
AL = flat A
AA
Area and L
LL
Largest average
6
AF = flat A
AA
Area and F
FF
First average
7
LF = flat L
LL
Largest and F
FF
First average
8
bLF = smooth L
LL
Largest or F
FF
First
9
bL = smooth L
LL
Largest only
Values
10
bF = smooth F
FF
First only
Select 1 for most applications and all mounting locations except the center of the vessel.
Select 6 for the center of the vessel mounting location and for still pipes and waveguide
antennas used as stillpipes.