User's Manual
Table Of Contents
- Table of Contents
- General Information
- Specifications
- Installation
- Location
- Dimensions: IQ Radar 300 with Rod Antenna
- Dimensions: Threaded Rod
- Dimensions: Horn
- Mounting
- Rod Assembly
- Mounting: Rod Assembly
- Mounting: Manhole Covers
- Mounting: Horn Antennas
- Mounting: Waveguide Antenna
- Mounting: Stillpipe or Sidepipe
- Mounting: Horn with Waveguide Extensions
- Mounting: Sanitary Mounting
- Mounting: Location
- Interconnection
- Start Up
- Operation(
- Application Examples
- Parameter Descriptions
- _
- _
- Quick Start Parameters (P001 to P007)
- Volume Parameters (P050 to P053)
- Display and Reading Parameters (P060 to P063)
- Fail-Safe Parameters (P070 to P072)
- mA Parameters (P200 to P219)
- Independent mA Setpoints Parameters (P210 and P211)
- Profile Record Parameters (P330 to P337)
- Auto Record ON and OFF Setpoint Parameters (P334 to P337)
- Installation Records Parameter
- Range Calibration Parameters
- Rate Parameters
- Measurement Verification Parameters
- Communication Parameters
- Echo Processing Parameters
- Algorithm Parameters
- TVT Adjustment Parameters
- P837 Auto Near TVT
- Test Parameters
- _
- Communications: Modbus Register Map
- Communications: Data Types
- Error Handling
- Troubleshooting
- Maintenance(
- Appendix I
- Appendix II
- Appendix III
- Appendix IV
- Appendix V
Page 42 IQ Radar 300 PL-611
Start Up
Start Up
Start Up
Start Up
2. Enter new value by pressing
the number key, e.g.
. To
erase value or incorrect entry,
press the CANCEL key
,
to
clear the value and then re-
enter correct value.
3. Press the ENTER key to set
the value.
Resetting a Parameter Value
1. Scroll to or select the
parameter.
2. Press the CANCEL key
and
then press the ENTER
key
.
The value returns to factory
default.
Accessing Run Mode
1. In PROGRAM mode, press the
PROGRAM key
. The screen
may go blank for a moment
2. The IQ 300 returns to RUN
mode.
Quick Start Programming
The first step in programming is to configure all parameters to their factory settings by
performing a master reset through Parameter 999 (see page 80).
Then set these key parameters (P001 to P007) for a Quick Start:
• (P001) mode of measurement • (P005) units
• (P002) process material • (P006) empty distance
• (P003) measurement response • (P007) span
• (P004) antenna configuration