User's Manual
Table Of Contents
- Table of Contents
- General Information
- Specifications
- Installation
- Location
- Dimensions: IQ Radar 300 with Rod Antenna
- Dimensions: Threaded Rod
- Dimensions: Horn
- Mounting
- Rod Assembly
- Mounting: Rod Assembly
- Mounting: Manhole Covers
- Mounting: Horn Antennas
- Mounting: Waveguide Antenna
- Mounting: Stillpipe or Sidepipe
- Mounting: Horn with Waveguide Extensions
- Mounting: Sanitary Mounting
- Mounting: Location
- Interconnection
- Start Up
- Operation(
- Application Examples
- Parameter Descriptions
- _
- _
- Quick Start Parameters (P001 to P007)
- Volume Parameters (P050 to P053)
- Display and Reading Parameters (P060 to P063)
- Fail-Safe Parameters (P070 to P072)
- mA Parameters (P200 to P219)
- Independent mA Setpoints Parameters (P210 and P211)
- Profile Record Parameters (P330 to P337)
- Auto Record ON and OFF Setpoint Parameters (P334 to P337)
- Installation Records Parameter
- Range Calibration Parameters
- Rate Parameters
- Measurement Verification Parameters
- Communication Parameters
- Echo Processing Parameters
- Algorithm Parameters
- TVT Adjustment Parameters
- P837 Auto Near TVT
- Test Parameters
- _
- Communications: Modbus Register Map
- Communications: Data Types
- Error Handling
- Troubleshooting
- Maintenance(
- Appendix I
- Appendix II
- Appendix III
- Appendix IV
- Appendix V
Page 40 IQ Radar 300 PL-611
Start Up
Start Up
Start Up
Start Up
Accessi
ii
ing Program Mode
Note
NoteNote
Note: Values shown are for demonstration purposes only.
1. The unit starts in RUN
RUNRUN
RUN
mode and readings
correspond to existing
settings.
2. Press the PROGRAM
PROGRAMPROGRAM
PROGRAM key
to activate the
PROGRAM
PROGRAMPROGRAM
PROGRAM mode. Initial
program starts at P001.
Accessing a Parameter
The parameter settings configure the units to a specific use. There are two ways to
access parameter after you have pressed the PROGRAM
PROGRAMPROGRAM
PROGRAM key: Scroll Access and Direct
Address.
Scroll Access
In PROGRAM
PROGRAMPROGRAM
PROGRAM mode, you can scroll through the parameters sequentially, and in either
direction until you reach the required parameter. [scrolling range??]
1. Press ARROW
ARROWARROW
ARROW keys
to scroll up or
down.
Direct Access
In PROGRAM
PROGRAMPROGRAM
PROGRAM mode, you can access a parameter directly by entering its number.