User's Manual
Table Of Contents
- Table of Contents
- General Information
- Specifications
- Installation
- Location
- Dimensions: IQ Radar 300 with Rod Antenna
- Dimensions: Threaded Rod
- Dimensions: Horn
- Mounting
- Rod Assembly
- Mounting: Rod Assembly
- Mounting: Manhole Covers
- Mounting: Horn Antennas
- Mounting: Waveguide Antenna
- Mounting: Stillpipe or Sidepipe
- Mounting: Horn with Waveguide Extensions
- Mounting: Sanitary Mounting
- Mounting: Location
- Interconnection
- Start Up
- Operation(
- Application Examples
- Parameter Descriptions
- _
- _
- Quick Start Parameters (P001 to P007)
- Volume Parameters (P050 to P053)
- Display and Reading Parameters (P060 to P063)
- Fail-Safe Parameters (P070 to P072)
- mA Parameters (P200 to P219)
- Independent mA Setpoints Parameters (P210 and P211)
- Profile Record Parameters (P330 to P337)
- Auto Record ON and OFF Setpoint Parameters (P334 to P337)
- Installation Records Parameter
- Range Calibration Parameters
- Rate Parameters
- Measurement Verification Parameters
- Communication Parameters
- Echo Processing Parameters
- Algorithm Parameters
- TVT Adjustment Parameters
- P837 Auto Near TVT
- Test Parameters
- _
- Communications: Modbus Register Map
- Communications: Data Types
- Error Handling
- Troubleshooting
- Maintenance(
- Appendix I
- Appendix II
- Appendix III
- Appendix IV
- Appendix V
Page 38 IQ Radar 300 PL-611
Start Up
Start Up
Start Up
Start Up
Programming
You can activate the PROGRAM
PROGRAMPROGRAM
PROGRAM mode at any time and set parameters to suit the
application and/or user preferences. Programming can be carried out locally using the
hand programmer or remotely through the optional Dolphin Plus/RS-485 interface. The
system responds to both types of programming.
The instruction examples in this manual use icons from the hand programmer.
Dolphin Plus
Dolphin Plus is a user interface program designed to configure the IQ Radar 300 from a
laptop or a desktop PC. With Dolphin Plus you can modify parameter values in real time,
view process values in graphic form on screen, save profiles, and generate instrument
configuration reports. Dolphin Plus software is purchased separately. Please contact
your Milltronics representative.
Hand Programmer
The programmer is a sturdy, hand-held, programming unit offering immediate access to
the configuration parameters. Point programmer at the IQ Radar 300 display window
(maximum distance 15cm [6”]) and press the buttons in the required sequence.
display
hand programmer
Dolphin Plus programming
interface