User's Manual
Table Of Contents
- Table of Contents
- General Information
- Specifications
- Installation
- Location
- Dimensions: IQ Radar 300 with Rod Antenna
- Dimensions: Threaded Rod
- Dimensions: Horn
- Mounting
- Rod Assembly
- Mounting: Rod Assembly
- Mounting: Manhole Covers
- Mounting: Horn Antennas
- Mounting: Waveguide Antenna
- Mounting: Stillpipe or Sidepipe
- Mounting: Horn with Waveguide Extensions
- Mounting: Sanitary Mounting
- Mounting: Location
- Interconnection
- Start Up
- Operation(
- Application Examples
- Parameter Descriptions
- _
- _
- Quick Start Parameters (P001 to P007)
- Volume Parameters (P050 to P053)
- Display and Reading Parameters (P060 to P063)
- Fail-Safe Parameters (P070 to P072)
- mA Parameters (P200 to P219)
- Independent mA Setpoints Parameters (P210 and P211)
- Profile Record Parameters (P330 to P337)
- Auto Record ON and OFF Setpoint Parameters (P334 to P337)
- Installation Records Parameter
- Range Calibration Parameters
- Rate Parameters
- Measurement Verification Parameters
- Communication Parameters
- Echo Processing Parameters
- Algorithm Parameters
- TVT Adjustment Parameters
- P837 Auto Near TVT
- Test Parameters
- _
- Communications: Modbus Register Map
- Communications: Data Types
- Error Handling
- Troubleshooting
- Maintenance(
- Appendix I
- Appendix II
- Appendix III
- Appendix IV
- Appendix V
PL-611 IQ Radar 300 Page 27
Installation
Installation
Installation
Installation
Mounting: Rod Assembly
Ideally, the standpipe should be as short as possible. If your
application requires a standpipe that exceeds our
recommended maximum lengths, consider using a waveguide
and horn combination. If you create a new standpipe for the
radar unit, ensure the weld seams are on the outside of the
standpipe, not the inside.
Ensure that there are no seams or lips on the inside of the
standpipe or you may get erratic readings.
If the mounting illustrated above is not suitable due to the minimum blanking
requirements, consider this option:
Standpipes that are 8” or larger in diameter provide excellent signal conditions. These
conditions allow for standpipe lengths of up to 24” using the standard rod without any
extensions.
minimum diameter 100mm (4”)
45°
Maximum length 610mm (24”)
No antenna extensions required
A
weld on outside
enclosure