User's Manual
Table Of Contents
- Table of Contents
- General Information
- Specifications
- Installation
- Location
- Dimensions: IQ Radar 300 with Rod Antenna
- Dimensions: Threaded Rod
- Dimensions: Horn
- Mounting
- Rod Assembly
- Mounting: Rod Assembly
- Mounting: Manhole Covers
- Mounting: Horn Antennas
- Mounting: Waveguide Antenna
- Mounting: Stillpipe or Sidepipe
- Mounting: Horn with Waveguide Extensions
- Mounting: Sanitary Mounting
- Mounting: Location
- Interconnection
- Start Up
- Operation(
- Application Examples
- Parameter Descriptions
- _
- _
- Quick Start Parameters (P001 to P007)
- Volume Parameters (P050 to P053)
- Display and Reading Parameters (P060 to P063)
- Fail-Safe Parameters (P070 to P072)
- mA Parameters (P200 to P219)
- Independent mA Setpoints Parameters (P210 and P211)
- Profile Record Parameters (P330 to P337)
- Auto Record ON and OFF Setpoint Parameters (P334 to P337)
- Installation Records Parameter
- Range Calibration Parameters
- Rate Parameters
- Measurement Verification Parameters
- Communication Parameters
- Echo Processing Parameters
- Algorithm Parameters
- TVT Adjustment Parameters
- P837 Auto Near TVT
- Test Parameters
- _
- Communications: Modbus Register Map
- Communications: Data Types
- Error Handling
- Troubleshooting
- Maintenance(
- Appendix I
- Appendix II
- Appendix III
- Appendix IV
- Appendix V
Page 12 IQ Radar 300 PL-611
Specifications
Specifications
Specifications
Specifications
Antennas:
• dielectric rod: Teflon
®2
(PTFE)
Ultra-high molecular weight Polyethylene
(UHMW-PE3)
Length 41cm (16.3”), including integral gasket
• horn: 316 stainless steel
diameters 100mm (4”), 150mm (6”),
200mm (8”)
emitter cone PTFE or UHMW-PE4
waveguide extensions optional
• waveguide: 316 stainless steel
emitter cone PTFE or UHMW-PE
4
Sanitary Antennas (FDA approved materials):
• dielectric rod: one piece UHMW-PE4, optional PTFE
2”, 3”, 4” tri-clamp connection
• horn: 304 stainless steel (316 special order)
horn with integral 4” tri-clamp
connection PTFE emitter
Enclosure (electronic):
• construction: aluminum, epoxy coated
• conduit: 2 x 1/2" NPT or PG 16 entry
• ingress protection: Type 6 / NEMA 6, IP-67
Weight:
• 6.5 kg (14.3 lb) with 2"/150 psi flange
• weight will vary with flange size and rating
Environmental:
• location: indoor/outdoor
• altitude: 2000m max
• ambient temperature: -40 to 60° C (-40 to 140° F)
4
• relative humidity: suitable for outdoor (Type 6/NEMA 6/IP 67
enclosure)
• installation category: II
• pollution degree: 4
Process
• material dielectric: ε
r
> 1.8
For ε
r
< 3, you should use a waveguide antenna
or stillpipe. (See Mounting: Waveguide Antenna
on page 29 or Mounting: Stillpipe or Sidepipe on
page 30.)
2 Teflon is a registered trademark of Du Pont.
3 Not available for CENELEC EEx approval.
4 See Temperature De-rating on page 97 and Approvals on page 13.