Owner`s manual

8.3 Uses of the Digital Controller
ON/OFF control
ON/OFF button. Press this button to power on and off. In the ON mode, the remote controller
displays the operation mode, clock, timer status, water tank bottom temperature and air temperature.
Note: your Solarstream has a power-off memory function. If you re-power the unit after power-off,
the unit will work again automatically to its previous settings. You can use either the digital controller
or the power switch for ON/OFF.
Water tank
bottom temperature
Ambient air
temperature
1
2
ELEC
TIMER
CLOCK
Button control area
Running status and parameter
setting display area
Operation mode display area
Clock and timing display area
Initialization mode
Standby mode
ELEC
TIMER
CLOCK
IN
OUT
8.2 Functional Illustration of the Digital Controller
ELEC
TIMER
CLOCK
OUT
CC
1
2
ELEC
TIMER
CLOCK
The electrical base box of the remote controller is of standard dimension(86 x 86mm), and the
fixed hole distance is 60mm. Before interior decoration, it is best to embed the box with
three-core cable into the wall. User interface and use functions are shown in the figure below.
Set the digital screen in the reverse procedure
as shown in Illustration 2 and Illustration 1 to
complete the mounting of the remote controller.
Put the remote controller in the electrical base
box and tighten the two screws.
Illustration 3
Illustration 4
Illustration 1
Illustration 2
Use flat screwdriver to press down the two tabs
and lift open the face covering.
Remove the top covering leftwards to disengage
two top tabs.
12
AIR TO WATER ALL IN ONE HEAT PUMP
8.1 Mounting and Fixing Method of the Remote Controller
NOTE: On this model, the Controller is fixed under the lid.