Owner`s manual

18
8.2b Initial Power On and Standby Status
After first powering on, the remote controller will show the full screen display. After 10 seconds, it will
show the Standby status with storage tank temperature, ambient air temperature and clock showing.
1
2
%%
Initialization status
ELECELEC
CLOCKCLOCK
TIMERTIMER
ELECELEC
CLOCKCLOCK
TIMERTIMER
Standby status
8.2c ON/OFF Control
ON/OFF button. Press this button to power on and off. In the ON mode, the remote controller
displays the operation mode, clock, timing status, bottom of water tank temperature and ambient temperature.
Notice: When the heat pump is turned on for the first time, the default 3 minute delay is not operational,
but will revert from the second time it is turned on.
Hot water
tank temperature
Ambient
temperature.
ELECELEC
CLOCKCLOCK
TIMERTIMER
8.2d Electric Heater Control
A: Independent electric heater mode:
Under the turn off status, press the button, you can turn on the independent electric heater mode the
sign of display on the interface like the picture 1. press the button again turn off the independent
electric heater mode like the picture 2.
B: Auxiliary electric heater mode:
Under the turn on status, press the button, you can turn on the auxiliary electric heater mode, the sign
of display on the interface like the picture 1. When the delay time which is begin when you turn on the
unit is longer than the parameter of 3 setting, the electric heater signal will output. Press the button again
turn off the auxiliary electric heater mode like the picture 2.
NOTE: The electric heater control is not applicable to Australian BOLT-ON Heat Pump models.
ELECELEC
ELECELEC
CLOCKCLOCK
TIMERTIMER
CLOCKCLOCK
TIMERTIMER
picture 1 picture 2
ElECElEC
CLOCKCLOCK
TIMERTIMER
ElECElEC
CLOCKCLOCK
TIMERTIMER
picture 1 picture 2
ELECELEC
ELECELEC
ELECELEC
ELECELEC
AIR TO WATER HEAT PUMP WATER HEATERAIR TO WATER HEAT PUMP WATER HEATER