Assembly Instructions

6.Switch to the blood pressure interface ⑩ to start measurement, and it will display blood pressure data after
it is completed.If the blood pressure cannot be measured, it always shows 000/000.The screen is
automatically turned off if there is no operation within a total of 70 seconds.
7. Press to the sleep interface 11 (gif) to display the duration of sleep last night.
8.Press touch button to blood oxygen interface 12 . The device will be calibrated in 3 seconds. After that, the
blood oxygen will be detected, and the blood oxygen data will be monitored in real time for 5 minutes
(including the calibration time) and then screen will be off. When wearing test fails, the device will not display
the data and the screen will be off. It is necessary to check whether the wearing is correct, and whether the
device sensor is close to the skin and there is no light leakage.
T i p s : T h e fa c t o r s t h a t a f f e c t t h e i n a cc u ra t e measurement of blood oxygen are as follows:
a.Vascular stains or external coloring products, such as nail polish or colored skin care products.
b.Swing your arm or exercise.
c.The sensor is not placed in correct position, which results in a penumbra effect.
d.Vascular contraction caused by temperature decrease.
e.Indoor strong light interference.
8. Power off: Press touch button to the power off interface 13 , long press 5 seconds to power off. (If there is
no operation in any interface in 5S, the screen is off automatically.)
APP data panel:
1. The data panel shows steps, sleep quality, heart rate, blood oxygen, HRV (Heart Rate Variability), etc.
Click on any of the data panel to enter the detailed record interface.