Assembly Instructions

After connecting, the device will automatically monitor the blood oxygen data from 00:00 to 07:00 every day
after opening this function. When the switch is turned off, there is no light on bracelet and it is not measured.
There is no data on the APP and background.
6.5 Disconnection reminder
After connecting normally,When the phone is far away from the safety distance of the bracelet, the bracelet
will continue to vibrate to remind you of the loss.
7.Take Photo
Enter into “My Device”On APP and then click the "Take Photo" , the phone directly enters into camera mode,
the camera icon 11 appears on the bracelet, shakes the bracelet (or clicks the bracelet touch button), the
mobile phone automatically takes a photo; click “back” button in the phone to exit the photo mode.
8. Reset device password:
In order to prevent the bracelet from being connected by others, you can set a password on the APP side,
open “reset device password” to set, the default password is "0000" for the first use, and then enter the new
password, click "Reset Password" to complete setting (when the password is set successfully, the bracelet
needs to be bound again). If you need to change the password, the old password is the password set
previously. If the password is forgotten, you can press and hold the bracelet for 6 seconds in sleep interface of
bracelet and then it will vibrate to clear the password. At this time, the device password is restored to the
default password: "0000". When the APP connects to the bracelet again, you do not need to enter the
password.
9. Firmware upgrade
When the new version of the bracelet device program is available, connect APP and it will prompt to update.