User's Manual

M3P U-series AC EV Charging Station User Manual
17
b) Pass the input cable through the cable protective ring, connect the power cable to the input
terminals; Reset the terminal box cover.
It is recommended to use flame retardant rubber copper core cable as the input cable, pass the cable
through the input interface of the Charger, then fix the Live wire, Neutral wire and GND wire to the
corresponding terminals, and finally fix the cable.
5.4.4. Step 4：Fixed the charger
Tighten the set screws on the left and right ends to fixed the charger.
Fig. 5-5 Fixed the wallbox
5.4.5. Empty socket
M3P U-series AC EV Charger config a type 1 charging connector.
When the Charger is in standby state, please plug the charging connector in the empty connector socket
in order to protect the charging connector.
Please use expansion screws to fix this empty socket at a suitable position beside the Charger.
Fig. 5-6 Empty socket