User's Manual

M3P U-series AC EV Charging Station User Manual

5.4.2. Step 2: Hang the charger on the accessory-D

Secure mounting accessories(A+B) to the charger; Follow the arrow, and hang the charger on

accessories-D.

Fig. 5-3 Hang the charger on the accessories-D

5.4.3. Step 3: Wiring network wire

If the CMS is to be connected through the network cable, put the network wire through the network wire

protective ring, then crimp the RJ-45 head, and then insert it into the network cable interface.

Fig. 5-4 Wiring network wire

The charger is equipped with a NEMA 14-50 plug that meets the NEMA standard. The length of the plug

cable is 300mm. The user should install a NEMA 14-50 receptacle in a suitable position of the charger.

Insert the plug into the socket to complete the wiring.

Note:

 Please select the cable diameter of the receptacle according to the rated current of the charger.

 The power supply of the charger should be equipped with a dedicated MCB.

In addition, if you need to replace the NEMA 14-50 plug cable, please follow the steps below:

a) Remove the of terminal box cover;