User's Manual

M3P U-series AC EV Charging Station User Manual

5.3. Installation preparation

5.3.1. Safety notes for installation

Refer to 2.3 for more safety notes.

Installation and wiring should be done by personnel with professional qualification,

otherwise, hazardous electric shock may result.

Make sure input power supply is entirely disconnected before wiring; otherwise,

hazardous electric shock may result.

Operator must always notice safe protection such as wear protective footwear, wear

goggles, otherwise it may be personal injury.

5.3.2. Tools for installation

Prepare the following tools at least before installing the M3P U-series AC EV Charger.

Sr No.

Tools’ Name Schematic Picture Main Uses

1 Multimeter

Check the electrical connection and

measure the voltage

2 Electric Impact drill

Drill fixing holes in the wall

3 Wrench

Fastening bolt

4 Diagonal pliers

Cut the cable

5 Wire stripper

Peeling cables

6 Crimping pliers

Pressed cable terminal

7 Cross screwdriver

Fastening screw

5.3.3. Ambient

a) Refer to 2.2 for more safety notes.