User's Manual

FCC NOTE FOR MODULER STATMENT
1.1 List of applicable FCC rules:
The module complies with FCC Part 15.247.
1.2 Summarize the specific operational use conditions:
The module has been certified for Fix, Mobile, Portable applications.
This transmitter must not be co‐located or operating in conjunction with any other antenna or
transmitter.
1.3 Limited module procedures:
The module has not its own RF shielding, which belong to limited module Standard requires:
Clear and specific instructions describing the conditions, limitations and procedures for third‐parties
to use and/or integrate the module into a host device (see Comprehensive integration instructions
below).
Resolve: Supply example as follows:
Installation Notes:
1) nRF52810 Module Power supply range is DC 3.3V, when you use nRF52810 Module design
product, the power supply cannot exceed this range.
2) When connect nRF52810 Module to the host device, the host device must be power off.
3) Make sure the module pins correctly installed.
4) Make sure that the module does not allow users to replace or demolition.
1.4 Trace antenna designs:
Not applicable.
1.5 RF exposure considerations:
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. The antenna(s) used for this transmitter must not
be collocated or operating in conjunction with any other antenna or transmitter.
Note: the host product manuals must include a statement in order to alert the users of FCC RF exposure
compliance.
1.6 Antennas
The antenna type is a dipole antenna, is permanently attached, can’t be replaced.
1.7 Label and compliance information
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.