Product Info
WF-R11M-RWG2
IEEE 802.11 b/g/n 1T1R UART SoC Module
四川爱联科技有限公司
Sichuan AI-Link Technology Co.,Ltd. page 7 of 8
§
15.19 Labelling requirements shall be complied on end user device.
Labelling rules for special device, please refer to
§
2.925,
§
15.19 (a)(5) and relevant KDB publications. For E-label,
please refer to
§
2.935.
FCC regulatory Compliance Statement mentioned in this manual shall be properly included in host product manual per FCC
Rules. The host product manufacturer shall be aware not to provide information to the end user on how to install or
remove this module in your host product manual.
2.9 Guide on test modes and additional testing requirements
Host product manufacturer is ultimately responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral requirements,
additional transmitter(s) in the host, etc.).
Furthermore, FCC KDB 996369 D04 Module Integration Guide v01 has elaborated guidance for modular transmitter
integration for host product manufacturers.
Test software access to different test modes:
XCOM V2.0.exe
2.10 Disclaimer on additional testing, Part 15 Subpart B compliance of Host Product
This modular transmitter is only FCC authorized for the specific rule parts listed on our grant, host product manufacturer is
responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of
certification.
Host manufacturer in any case shall ensure host product which is installed and operating with the module is in compliant
with Part 15B requirements.
Please note that For a Class B or Class A digital device or peripheral, the instructions furnished the user manual of the
end-user product shall include statement set out in
§
15.105 Information to the user or such similar statement and place it
in a prominent location in the text of host product manual. Original texts from FCC Rules are as following you may refer to:
For Class B
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipm
ent does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—
Reorient or relocate the receiving antenna.
—
Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—
Consult the dealer or an experienced radio/TV technician for help.
ISED Regulatory Compliance
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1)This device may not
cause interference.(2)This device must accept any interference, including interference that may cause undesired operation
of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :(1)L’appareil ne doit pas produire de brouillage; (2)L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.