Specifications

Sichuan AI-Link Technology Co., Ltd.
page 7 of 9
Noet: No marked size tolerance: ±0.2mm
7、Statement：
A、CE Radiation Exposure Statement
Herby, declares that this WiFi Module, WF-M68A-UWF1
is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
In accordance with Article 10(2) and Article 10(10), this product allowed to be used in all EU member states.
Use the WIFI Module in the environment with the temperature between -10 and 70
This device is restricted to indoor use where operated in the European Community using
frequency in 5150-5350MHz, 5470-5725MHz, 5745-5825MHz to reduce the potential for interference.
Operation Frequency:
5G Wifi: 0.0586W 5.8G Wifi: 0.0176W
BT:0.0039W BLE: 0.0032W
Max output power: 2.4G WIFI: 0.0551W
Manufacturer: Sichuan AI-Link Technology Co., Ltd.
Address:
Anzhou, Industrial park, Mianyang, Sichuan, China
Tel: [phone]
Fax:
[phone]
E-mail: [e-mail]
Sichuan AI-Link Technology Co.,Ltd.
B、FCC Radiation Exposure Statement
FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247 and FCC CFR Title 47 Part 15 Subpart
E Section 15.407: 2016
PCB antenna (BT/BLE)with Gain: 2dBi, Internal antenna(2.4G WIFI/5G WIFI/5.8G WIFI) with 2.4G Wifi gain
2dBi, and 5G Wifi gain 2dBi and 5.8G Wifi gain 2dBi
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
If power exceeds the limit and the distance( Over 20cm distance in actual use between the device
and user) is compliant with the requirement.
For BT/BLE:2402MHz~2480MHz
For 2.4G WIFI:
2412MHz~2472MHz (802.11b/802.11g/802.11n(HT20))
2422MHz~2462MHz (802.11n(HT40))
For 5G WIFI:
5150MHz-5350MHz, 5470MHz-5725MHz, 5745MHz-5825MHz