Specifications

WF-M63B-USX3
IEEE 802.11a/b/g/n/ac2T2R USB WIFI Module&BT2.1+EDR/4.2/5.1
Sichuan AI-Link Technology Co.,Ltd.page 23 of 25
Requirement per KDB996369 D03
1.1 List of applicable FCC rules
List the FCC rules that are applicable to the modular transmitter. These are the rules that
specifically establish the bands of operation, the power, spurious emissions, and operating
fundamental frequencies. DO NOT list compliance to unintentional-radiator rules (Part 15
Subpart B) since that is not a condition of a module grant that is extended to a host
manufacturer. See also Section 2.10 below concerning the need to notify host manufacturers
that further testing is required.3
Explanation: This module meets the requirements of FCC part 15C(15.247).
1.2 Summarize the specific operational use conditions
Describe use conditions that are applicable to the modular transmitter, including for example any limits
on antennas, etc. For example, if point-to-point antennas are used that require reduction in power or
compensation for cable loss, then this information must be in the instructions. If the use condition
limitations extend to professional users, then instructions must state that this information also extends to
the host manufacturer’s instruction manual. In addition, certain information may also be needed, such as
peak gain per frequency band and minimum gain, specifically for master devices in 5 GHz DFS bands.
Explanation: The EUT has a FPC Antenna, , and the antenna use a permanently attached antenna
which is not replaceable.
1.3 Limited module procedures
If a modular transmitter is approved as a “limited module,” then the module manufacturer is responsible
for approving the host environment that the limited module is used with. The manufacturer of a limited
module must describe, both in the filing and in the installation instructions, the alternative means that the
limited module manufacturer uses to verify that the host meets the necessary requirements to satisfy the
module limiting conditions.
A limited module manufacturer has the flexibility to define its alternative method to address the
conditions that limit the initial approval, such as: shielding, minimum signaling amplitude, buffered
modulation/data inputs, or power supply regulation. The alternative method could include that the limited
module manufacturer reviews detailed test data or host designs prior to giving the host manufacturer
approval.
This limited module procedure is also applicable for RF exposure evaluation when it is necessary to
demonstrate compliance in a specific host. The module manufacturer must state how control of the
product into which the modular transmitter will be installed will be maintained such that full compliance of
the product is always ensured. For additional hosts other than the specific host originally granted with a
limited module, a Class II permissive change is required on the module grant to register the additional
host as a specific host also approved with the module.
Explanation: The module is not a limited module.