Installation Instructions

Le présent appareil est conforme aux CNR d'Industrie Canada applicable aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement
1,This modular complies with IC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be collocated or operating in conjunction with antenna or transmitter.
If the IC identification number is not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display label
referring to the enclosed module. This exterior label can use wording such as the following: Contains
2,The devices must be installed and used in strict accordance with the manufacturer's instructions
as described in the user documentation that comes with the product. This device is intended only
for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and user.
2) The transmitter module may not be co-located with any other transmitter or antenna.
Module Antenna Type: Integral Antenna, ANT Gain: 2dBi
3,This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum
distance of 20cm between the radiator
and any part of your body.
Transmitter Module IC number: 23460-WFM601UWS3 Or Contains IC number: 23460-WFM601UWS3
when the module is installed inside another device.
Cet équipement est conforme aux limites d'exposition aux rayonnements ISED définies pour un
environnement non controlé. Cet équipement doit être installé et utilisé avec un minimum de
distance de 20cm entre le radiateur et n'importe quelle partie de votre corps.
IC Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
The term “IC: “ before the certification/registration number only signifies that the
Industry Canada technical specifications were met. This product meets the applicable
Industry Canada technical specifications.
Upgrade Firmware:
The software provided for firmware upgrade will not be capable to affect any RF parameters as
certified for the FCC for this module, in order to prevent compliance issues.
End product labeling:
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users. The final end
product must be labeled in a visible area with the following: “Contains FCC ID: 2AOKI-WFM601UWS3”.
Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module in the user's manual of the end product which integrates
this module. The end user manual shall include all required regulatory information/warning
as show in this manual.
WF-M601-UWS3
WiFi Module
Sichuan AI-Link Technology Co., Ltd.
page 15 of 16