User manual

7
mode
Open the door - Bright - D i
Alarm Bright - - Alarm
11. Detailed Programming Guide
11.1 User Settings
To enter the programming mode
999999 is the default factory master code
To exit from the programming mode
Note that to undertake the following programming the master user must be logged in
To change the master code
Themastercodecanbe6to8digitslong
Setting the working mode:
Set valid card only users
Set valid card and PIN users
Set valid card or PIN users
Entry is by card only
Entryisbycardand PIN together
Entryisbyeithercardor PIN (default)
To add a user in either card or PIN mode, i.e. in the mode. (Default setting)
To add a Pin user
The ID number is any number between 1 & 2000. The
PIN is any four digits between 0000 & 9999 with the
exception of 1234 which is reserved. Users can be added
continuously without exiting programming mode as
follows:
To delete a PIN user
Users can be deleted continuously without exiting
programming mode
To change the PIN of a PIN user
(This step must be done out of
programming mode)
To add a card user (Method 1)
This is the fastest way to enter cards,
user ID number auto generation.
Cards can be added continuously without exiting
programming mode