Standalone Keypad Access Control User Manual Please read the manual carefully before use this unit
1. Packing List Name Quantity Remarks Keypad 1 User manual 1 Screw driver 1 Φ20mm×60mm,Special for keypad Rubber plug 2 Φ6mm×30 mm, used for fixing Self tapping screws 2 Star screws 1 Φ4mm×28 mm, used for fixing Φ3mm×6mm, used for fixing Please ensure that all the above contents are correct. If any are missing please notify the supplier of the unit. 2.
programming mode To unlock the door for a PIN user Enter the then press To unlock the door for a card user Present the card 3. Description The unit is single door multifunction standalone access controller or a Wiegand output keypad or card reader. It is suitable for mounting either indoor or outdoor in harsh environments. It is housed in a strong, sturdy and vandal proof Zinc Alloy electroplated case which is available in either a bright silver or matt silver finish.
5. Specifications Operating Voltage DC 12V±10% User Capacity 2000 Card Reading Distance 3-6 cm Active Current ＜60mA Idle Current 25±5 mA Lock Output Load Max 3A Alarm Output Load Max 20A Operating Temperature -45℃～60℃ Operating Humidity 10%- 90% RH Waterproof Conforms to IP68 Adjustable Door Relay time 0 -99 seconds Adjustable Alarm Time 0- 3 minutes Wiegand Interface Wiegand 26 bit Wiring Connections Electric Lock, Exit Button, External Alarm,External reader 6.
7.
special power supply diagram: 8. To Reset to Factory Default a. Disconnect power from the unit b. Press and hold # key whilst powering the unit back up c. On hearing two “Di” release # key, system is now back factory settings Please note only installer data is restored, user data will not be affected 9. Anti Tamper Alarm The unit uses a LDR (light dependent resistor) as an anti tamper alarm. If the keypad is removed from the cover then the tamper alarm will operate. 10.
mode Open the door Alarm - Bright - Di Bright - - Alarm 11. Detailed Programming Guide 11.
To add a card user (Method 2) This is the alternative way to enter cards using User ID Allocation. In this method a User can be added continuously without exiting programming mode User ID is allocated to a card. Only one user ID can be allocated to a single card.
programming mode so the user can undertake this themselves To delete a Card and PIN user just delete the card To add a card user in card mode ( To Add and Delete a card user ) The operating is the same as adding and deleting a card user in To delete All users To delete ALL users.
11.2 Door Settings Relay Output Delay Time To set door relay strike time 0-99 is to set the door relay time 0-99 seconds Door Open Detection Door Open Too Long (DOTL) warning. When used with an optional magnetic contact or built-in magnetic contact of the lock, if the door is opened normally, but not closed after 1 minute, the inside buzzer will beep automatically to remind people to close the door and continue for 1 minute before switching off automatically. Door Forced Open warning.
12.The unit operating as a Wiegand Output Reader In this mode the unit supports a Wiegand 26 bit output so the Wiegand data lines can be connected to any controller which supports a Wiegand 26 bit input.
