Use and Care Manual

Step 3:
3.1 Assembling frame tightened with M6 screws.M6 screws using the supplied spanner .
3.2 Then install the two side bracket with M6 screws.M6 screws using the supplied spanner .
3.3 Use M4 screws to fix the hook to the side bracket.M4 screws using the supplied screwdrive .
J
O
1
J
O
1
O
3
Step 4:
4.1 As shown in Figure 1,insert the hexagonal bar into the table leg A until the buckle is not visible.
4.2 Attach the other end of the connecting rod to the tanle leg B and screw on the handle. The
handle dose not need to be tightened. Note: As shown in Figure 2 below, it needs to be aligned
with the card slot.
4.3 Pull the connecting rod with the handle to the bottom end of the table leg A in the direction of
the arrow as follws.
4.4 Tighten the handle and install the M4 screws. M4 screws using the supplied screwdriver .
K
O
3
O
3
On the card solt
Tightened
E
3
J
J
D
3
2
1
K
F
E
2
E
1
O
3
O
1