Instructions Manual
IMPORTANT SAFEGUARDS Read these instructions carefully and retain them for future use. When using the product, basic safety precautions should always be followed to reduce the risk of injury including the following: ●Unpack all hardware bags and components to ensure you have all the parts. ●Use the tools included to assemble the desk, don’t use the incorrect tools to assemble. ●Do not climb, stand or sit on the desk. ●Do not place objects on the desk when moving.
Parts List A Lift column*1 B Lift column*1 C Base*2 D Frame*2 D2 D1 E Side bracket*2 + Pothook*1 F Motor Rod*1 M4 screws*2 E1 E2 E3 G Desk top*3+Wooden pin*8 H Desktop connection block*1 Desktop connection block*2 Power supply holder*1 Pen box*1 G2 ① ② ③ G1 I Handset + Power supply Power cord I1 I 2 H1 G3 I 3 J M6 screws*28 L Tapping screws*6 N M6 screws*2 J K L H2 K M4 screws*1 O 5# wrench*1 6# wrench*1 M M10 screws*8 cross screwdriver*1 M N O1 O2 O3
Assembly steps Step 1: 1.1 Connect the board ①②③ pay attention to the dirction of the board with wooden pins.As shown in the figure. 1.2 Fasten connecting blocks H1 and H2 with J M6 screws as shown in the figure.M6 screws using the supplied spanner O . 1.3 The hand controller is fastened to the table with L self-tapping screws.Self-tapping screws using the supplied screwdriver O . 1.4 Pay attention to the direction. 1.5 Fasten D1 and D2 with N M6 screws as shown in the figure.
Step 3: 3.1 Assembling frame tightened with J M6 screws.M6 screws using the supplied spanner O . 3.2 Then install the two side bracket with J M6 screws.M6 screws using the supplied spanner O . 3.3 Use M4 screws to fix the hook to the side bracket.M4 screws using the supplied screwdrive O . 1 1 3 O 1 O J E2 3 E3 E1 J D Step 4: 4.1 As shown in Figure 1,insert the hexagonal bar into the table leg A until the buckle is not visible. 4.
Step 5: After connected three desk top with pins and put on the frame and tightened with J M6 screws. M6 screws using the supplied spanner O . Place the panbox on the desk top and lock it with self-tapping screws. Self-tapping screws using the supplied screwdriver O . 1 3 O 1 O 3 Same side L G3 J Step 6: Install the wire box, arrange the wire, and complete the installation.
Operational instructions 1. Lift Column Press the button or button to control the lift column up or down Press the button to control up of the lifting column, you can see the height (displayed number) on the screen; press the button to control the down of the lifting column, you can see the height (displayed number) on the screen. 2. Set memory height Press( ) button for 2 seconds, set the current height to the memory height, When flashing display "H1~H4"2 seconds, after 2 seconds display real-time height.
