Software Manual

ALFOplus 24GHz (North America) - Release 01.05.0x - MN.00395.E - 004 115
Fig.82 - Rescue connection using WLC
9.5 INITIALIZATION PROCEDURE
To activate a radio link it is necessary to program the ODU (local and remote side) in some basic items
listed in the following:
• bandwidth & modulation
• Tx frequency & power
•port configuration
• agent IP address and equipment ID
• store routing table
• remote element list
• restart equipment
Bandwidth and Modulation setting
See Fig.83.
Into WebLCT at position:
• Equipment menu
• Equipment - BW & MOD/LINK ID
•In Capacity and Modulation card, you can select Bandwidth&Modulation desired. Press Apply
and Confirm
• Enable or disable ACM Engine, if you want dynamic modulation. Press Apply and Confirm
Warning: Use the same parameters on remote unit.