Software Manual
ALFOplus 24GHz (North America) - Release 01.05.0x - MN.00395.E - 004 125
After checking commissioning measures it is mandatory to fill “SIAE commissioning report” and send it to
SIAE database, ready to be checked when necessary.
These reports are very important for SIAE and for the customer because they certify the conformity of SIAE
link.
Only in case you don’t have this document, the full backup file .bku can be generate using SCT.
9.9 FIRMWARE UPDATE
Firmware can be updated using the software SCT or WebLCT Console. There are two different memory
benches: one containing the running firmware and the other the stand-by firmware. This permits to down-
load a new firmware release to the stand-by bench without cutting the traffic.
Use the “Bench Switch” to activate the bench in stand-by (SW restart will be performed). There is a firm-
ware version for both ODUs GE and GO:
• N10052 - ALFOplus: radio full outdoor with transport of IP Ethernet traffic.
9.9.1 Scope
Scope of this paragraph is to provide a procedure that described, step by step, how to perform the software
upgrade of ALFOplus equipment.
Downloading time depends on the connection used between PC and ALFOplus.
Warning: In order to transfer data “Web LCT console” or “Subnetwork Craft Terminal” running is necessary.
Virtual Lan (802.1Q)
Port Based VLAN
LAN1 / Disable Enable / Disable Enable
LAN2 Disable / Enable Disable / Enable
Port A Enable Enable / Enable Enable /
802.1q Management Fallback Disable Fallback Fallback Disable Fallback
Default Vid 101 102 111 101 102 111
Priority 802.1P
Port default
0
Port default
7
Port default
0
Port default
7
Ethernet Switch
Max Packet size 2048 byte
Mac address
aging time
300 sec
QinQ ETH Type 9100
Priority
Radio to Lan
Native 802.1p
Priority
LAN to radio
Native 802.1p
Local Terminal Remote terminal
LAN1 LAN2 PORT A LAN1 LAN2 PORT A