Instruction manual

Chapter 1 Basic Operation CVS-128
1-12 0093112802-00
Fishing hot spot
Leads you back to your favorite fishing hot spots
or other previously stored positions in memory
with input from optional GPS sensor. (See [2.13
Preset/ WPT edit/ WPT delete of Destination])
To perform the fishing hot spot, it is necessary to
select [System] → [EVENT key set] → [Fishing
hot spot]. (See [1.7 Use of [EVENT] key
Selecting the event])
1 In the state that no other key is pressed,
press the [ ] key or the [ ] key.
2 Move the cursor (red line) to a point you
desire to go back with the [ ] key or [ ] key.
3 Press the [EVENT] key.
When you decide, the red line is drawn on
the image of the fish finder at the point you
designate and the latitude and longitude of
the point you designate is stored in the
destination list.
At this moment, the number of the stored
destination list is displayed.
4 The navigation display (NAV1) is displayed
and the WPT navigation starts.
5 To stop the fishing hot spot, delete
destination navigation. (See: [2.13 Preset/
WPT edit/ WPT delete of Destination],
[Cancel the NAV].)
Note: The display of NAV1 is displayed.
1.8 Use of [F1] / [F2] key
When factory-shipped, the [Image Speed] is
assigned to the [F1]/[F2] key. The function
settable to the [F1]/[F2] key can be selected
among [Image Speed], [IR], [Color Rejection],
[Noise Rejection], [Shift], [Zoom Range], [Zoom
Start], [A scope], [White line], [Background color],
[Disp width], [Nav start], [NAV1], [NAV2], [Image
swap], [Image recal] and [Sona-tone]. Set the
function frequently used for your convenience.
Selecting the [F1]/[F2] key
1 Press the [F1] key or [F2] key.
2 Select the setting with [
]
key or [
]
key.
Example [Image speed]
Image Speed
2/1
1/1
stop
1/1.5
1/2
1/2.5
1/3
1/3.5
1/4
1/4.5
3 Press the [MENU] key to close the menu.
Cursor
(Redline)
L H
L H