Instruction manual

CVS-126 Chapter 5 Installation
0093132702-01 5-8
Connection of Power Cable and Transducer
Connect the power cable to the [POWER] connector and the transducer to the [TD] at the rear of
CVS-126 Display unit connector.
Connection of DC power cable (CW-264-2M)
To [POWER] connector
3.5 stereo jack
DC+ (Red)
DC- (Black)
Caution: Wind the insulation tape around the un-used lead wire for core-wires not to contact
each other.
Connection of transducer
To [TD] connector
Grounding
• Use heavy gauge cable for grounding wire.
• Connect the grounding wire to the grounding material in a short distance.
• When connecting the external equipment of which positive polarity is connected to the ground line,
do not connect the ground of signal line to the cabinet ground.
Connection with external equipment
The DC power cable contains the connection cables for external equipment such as navigation
equipment and KODEN GPS sensor.
Color Pin Remark
Red ③ Power input+ (with 2A fuse)
Black ⑨ Power input- (with 2A fuse)
Orange ⑥ NMEA data output +
Blue ⑤ NMEA data output -
White ⑦ NMEA data input +
Green ⑧ NMEA data input -
Color Pin Remark
White ②
Red ①
Black ⑪
External speaker output
(with ø3.5 stereo jack)
Yellow ⑫ Outside power
Gray ④ GND
Shield ⑩