Instruction manual

Chapter 5 Installation CVS-126
5-5 0093132702-01
5.3
5.35.3
5.3 Installation of Transducer
The standard installation of this echo sounder is shown in figure 5.5.
Figure 5.5 Installation of Transducer
In case of Inner-Hull
Using the optional inner-hull kit (MFB-04), install the transducer to the inner side of ship’s bottom.
Caution on installation
Figure 5.6 Inner-Hull Installation
(1) Select the location where no bubble is generated during navigation.
(2) Select the relatively thin location of ship’s bottom.
(3) Be sure to remove oil on the contact surface. File the contact surface with sand paper (#400) so
that the adhesive strength will increase.
(4) The adhered surface will dry in about two hours.
(5) Leave the unit for a whole day and fill in the coolant. More than 80% of the transducer should be
submerged in the coolant.