Manual

178
9. Finally press OK to confirm your setting.
10. Repeat steps 2-7 to set a complete week-long programme of start and end times, offering
seven days with up to six operating periods per day.
11. To change a setting, go through the process described above and overwrite the current
values. Confirm with OK.
12. To deactivate the week timer, press the P button again. The ‘P’ disappears from the display
and the week programme is disabled. The appliance returns to its previous function.
NOTE
The week timer works in a continuous cycle, recommencing with day 1 after reaching day 7. If
you do not want this, deactivate the week timer using the P button.
Remarks:
• To check your settings, press the following sequence of buttons: DAY, EDIT, TIME/ON and
TIME/OFF. The settings appear on the display.
• The timer can be set to whole hours but not to minutes.
• TIME/OFF must always be later than TIME/ON.
• If the appliance is switched off at the main switch, if there is a power failure or if the plug is pulled
out, all settings are lost. Press SET to check the set day and time and to set them if necessary.
Switching the Open Window function on and off:
• Check that the appliance is on and is heating.
• Press . The relevant symbol and °C appear on the display.
The default setting is 23°C. You can set your desired temperature using the plus and minus
buttons. If open window detection is active, the appliance will switch off and go into standby mode
if the temperature in the room falls by 5-10°C within ten minutes.
You can then switch the appliance back on with the ON/OFF button.
• To deactivate open window detection, press the button again. The symbol disappears from
the display and the appliance resumes the previously set operation.
• If you activate open window detection while the appliance is operating in a preset week
programme, the open window detection will only function during the operating times that are set in
the programme.