Manual

177
Week timer:
To set the week timer, the current date and time must have already been set; see the section
‘Setting the day and time’ above.
1. Switch the appliance on with the ON/OFF button .
2. Now press . The display shows ‘P’ in the top left corner and changes to week timer
setting, see Fig. D.
3. Now press . The display shows ‘d1’. Cycle through to the day you require by pressing DAY
repeatedly: d1 = Monday, d2 = Tuesday etc.
If you are making a setting for Mondays, the display appears (flashing) as in Fig. E.
4. Now press . The display shows ‘P1’ (Programme 1). You can set up to six time periods, P1
to P6, for each day. Press EDIT again, then go to P2, and so on. Set the first period (P1), and
then the display appears (flashing) as in Fig. F.
5. Now press . The display shows the default value ‘00’. Press TIME/ON repeatedly to set the
start time (0-24), e.g. to 07:00, see Fig. G.
6. Now press . By default the display now shows the start time. Press TIME/OFF repeatedly
to set the end time (0-24), e.g. to 13:00, see Fig. G.
Note that the end time must always be later than the start time! If the two times are identical, the
appliance goes into standby mode.
7. Use the plus and minus buttons to set the required temperature.
8. While a value is flashing, you can change it or move to the next setting. If you wait too long, the
settings mode is cancelled.