Manual

176

• The timer button on the remote control functions in exactly the same way as that on the

appliance.

Setting the day and time:

• Press the SET button once: the display shows ‘12’.

Now use the plus and minus buttons / to set the hour of the current

time (0-23).

Press SET again to display the minutes. The display shows ‘30’ and you can use

the plus and minus buttons to set the minutes of the current time (0-59).

Now press SET again. The display shows ‘d7’ ( ); you can now use the plus and minus buttons

to set the day of the week as follows: Monday = d1, Tuesday = d2, etc.

Finally, press to confirm your settings. The display now resorts to what it was indicating

before you made the settings.

To check the day and time, press SET.

Setting the temperature:

• Press the plus or minus button while the appliance is in operation. The display

shows the default value ‘23’. Next, press the plus or minus button to set the

desired temperature (10-35°C). Press OK to confirm your setting. The display

now shows the set temperature and the power level.

• Once you have set the temperature, the appliance itself selects the power level

required to reach it: if the temperature must be increased by more than 2°C, it

selects full power, but if the increase is less than 2°C, it operates at half power.

Once the set temperature is reached or exceeded, the heating element is

switched off and the fan continues to run for 3 more minutes.

The appliance thus keeps the air moving in the room and can thereby detect whether the room

temperature is falling. After 3 minutes the appliance returns to standby mode.

If by now the room temperature has fallen to 2°C below the set room temperature, the appliance

starts up again.

• To override the thermostat, press the function button and select half or full power. The

appliance now runs continuously. The temperature disappears from the display, which now

changes to that of either Fig. B or Fig. C.

After twelve hours of continuous operation the appliance switches off automatically and returns to

standby mode.