Manual

175
• Press the Function button (F) once. The appliance starts to
blow cold air and the display appears as in Fig. A.
• Press F a second time and the appliance begins to heat at
half power. The display appears as in Fig. B.
• Press F a third time and the appliance heats at full power.
The display appears as in Fig. C.
• Pressing the button a fourth time returns the appliance to standby (‘S’) mode. The appliance now
enters a cooling phase for 3 minutes.
• You can use the timer button (clock symbol) to set a specific start time. To do this, put the
appliance into standby (‘S’) mode and press the Timer button.
Each subsequent press of the Timer button increases the delay time before operation by one
hour. The display indicates the number of hours set and the time remaining. The timer indicator
lamp illuminates.
Once the set time is reached, the appliance starts automatically. The temperature is preset to
23°C. The temperature can be adjusted using the remote control but not using the buttons on the
appliance itself.
• If no week timer is set and no temperature has been set with the remote control, the appliance
switches itself off after twelve hours of operation.
Operation with the remote control:
NOTE
The remote control unit only works when its sensor is aimed directly at the bathroom fan
heater.
The appliance must be in standby mode
(Check the display)
• Press the ON/OFF button to switch the appliance on. The display
appears as in Fig. A.
• Now press the remote control function button once to heat at half power.
The display appears as in Fig. B.
• Press a second time and the appliance heats at full power. The display appears
as in Fig. C.
• Press a third time and the appliance returns to Standby mode (see Fig. A.).