Manual

174
1. Fit the mounting brackets to the top of the bathroom fan heater with the short side to the wall.
Place against the wall, mark the drilling hole positions on the wall and remove the heater.
2. Drill two 8-mm holes in the wall at the places marked, horizontal and with a spacing of 18.7 cm.
3. Insert rawl plugs into the holes and insert the screws (supplied). Tighten the screws until they
protrude by about 5 mm.
4. Mount the fan heater by hooking the mounting brackets over the screws. Slide unit fully to the
left and pull it downwards.
Starting up and functions
• The main switch must be in the Off (O) position.
• Unwind the power cable completely and insert the plug into a suitable
220-240 V~ socket.
• Press the main switch (I). The display shows ‘S’ (standby mode).
Operation with the control panel: