Manual

37
2. Set temperature:
During operation, press " / ", the display shows "23" as the default value. Press "
/ " to set the desired temperature (temperature range 10-49℃) and press " " to
confirm the setting.
Example: The current ambient temperature is 15℃. If you want to set the temperature to
25℃, the display will be as follows:
Hint:
SMART mode is used when setting the temperature:
1. Setting temperature - ambient temperature> 2 ℃, operates at high power;
2. 0 ℃ <setting temperature - ambient temperature = <2 ℃, operates at low power;
3. Setting temperature - ambient temperature = 0 ℃, the cooling fan operates for 30 seconds
to dissipate the remaining heat, then the unit goes into standby mode.
4. After entering standby mode, when the unit cools down and:
5. Setting temperature - ambient temperature> = 2 ℃, the unit wakes up and continues
heating.
6. If you want to cancel the setting temperature, press the " " button to select "Heating" "
" or "Ventilation" " ", then the appliance operates without setting temperature. The
" ℃ " display is switched off.
Set the weekly programme (ONLY via the remote control).
After completing the setting of CURRENT TIME / DAY, these are the steps for setting the weekly
programme:
1. Press " ", the product changes to working status.
2. Press " ", "P" lights up and it is set in the weekly programme: See below: A
3. Press " ", the display shows d1 ~ d7 and is set to working days (Monday-Sunday: d1 ~
d7). For example, Monday is set: see below: B
4. Press " ", the display shows P1 ~ P6 (a maximum of 6 periods can be set for each
day). How to set P1: see below: C
5. Press " ", the display shows "00" as the default. Press " " continuously to set the
switch-on time. For example, the switch-on time is set to 7:00 am (Note: The setting time is
0-24 for selection): see below: D